Journal of Conservative Dentistry
Home About us Editorial Board Instructions Submission Subscribe Advertise Contact e-Alerts Login 
Users Online: 942
Print this page  Email this page Bookmark this page Small font sizeDefault font sizeIncrease font size
ORIGINAL RESEARCH ARTICLE
Year : 2018  |  Volume : 21  |  Issue : 2  |  Page : 194-197

Effect of acid etching on the micro-shear bond strength of resin composite–calcium silicate interface evaluated over different time intervals of bond aging


Department of Conservative Dentistry and Endodontics, Maulana Azad Institute of Dental Sciences, New Delhi, India

Correspondence Address:
Dr. Sangeeta Talwar
Head of the Department, Department of Conservative Dentistry and Endodontics, Maulana Azad Institute of Dental Sciences, MAMC Complex, Bahadur Shah Zafar Marg, New Delhi - 110 002
India
Login to access the Email id

Source of Support: None, Conflict of Interest: None


DOI: 10.4103/JCD.JCD_167_17

Rights and Permissions

Introduction: With the introduction of calcium silicate materials, pulp capping procedure has been simplified due to their therapeutic pulp capping capabilities and ability to be used as a provisional bulk restorative material simultaneously. The quality of the adhesive bond between these cements and composite is of clinical significance with regard to the longevity of the final laminate restoration. Thus, this study aims to compare the in vitro microtensile bond strengths of resin composite to different calcium silicate cements versus glass ionomer cement (GIC). Materials and Methodology: Resin composite was bonded to standardized disks of Biodentine, mineral trioxide aggregate (MTA), and GIC. The samples were divided into the following three groups, and each group was further divided into two subgroups based on the aging time (1 and 2 weeks) of the samples: (1) Group 1 – phosphoric acid etching on Biodentine. (2) Group 2 – phosphoric acid etching on MTA. (3) Group 3 – phosphoric acid etching on GIC. After bond aging, the microtensile bond strength was analyzed using the Instron universal testing machine. Results: There was no significant difference in micro-SBS between 1- and 4-week bond aging of MTA and Biodentine group, while a significant decrease is seen in the GIC group. Conclusion: Calcium silicate cements are weak in the early setting phase. Thus, placing the overlying composite is best delayed for at least 2 weeks to allow adequate maturation of the material.


[FULL TEXT] [PDF]*
Print this article     Email this article
 Next article
 Previous article
 Table of Contents

 Similar in PUBMED
   Search Pubmed for
   Search in Google Scholar for
 Related articles
 Citation Manager
 Access Statistics
 Reader Comments
 Email Alert *
 Add to My List *
 * Requires registration (Free)
 

 Article Access Statistics
    Viewed933    
    Printed23    
    Emailed0    
    PDF Downloaded117    
    Comments [Add]    

Recommend this journal